Cabletron Systems SmartSwitch 8-slot, Руководство пользователя

Страница: 119 / 150

Chapter 8: IPX Routing Configuration Guide
SSR User Reference Manual 8 - 3
IPX SAP
On the SSR, SAP automatically runs on all the IPX interfaces. The SSR will keep
multiple SAP’s having the lowest hop count. Static SAPs can be configured on the SSR
using the CLI’s ipx add sap command. Through the use of SAP filters, the SSR can
control the acceptance and advertisements of services per-interface.
Creating IPX Interfaces
When you create IPX interfaces on the SSR, you provide information about the
interface (such as its name, output MAC encapsulation, and IPX address). You also
enable or disable the interface and bind the interface to a single port or VLAN.
Note:
Interfaces bound to a single port go down when the port goes down but
interfaces bound to a VLAN remain up as long as at least one port in that
VLAN remains active.
The procedure for creating an IPX interface depends on whether you are binding that
interface to a single port or a VLAN. Separate discussions on the different procedures
follow.
IPX Addresses
The IPX address is a 12-byte number divided into three parts. The first part is the 4-
byte (8-character) IPX external network number. The second part is the 6-byte (12-
character) node number. The third part is the 2-byte (4-character) socket number.
Configuring IPX Interfaces and Parameters
This section provides an overview of configuring various IPX parameters and setting
up IPX interfaces.
Configure IPX Addresses to Ports
You can configure one IPX interface directly to a physical port.
To configure an IPX interface to a port, enter one of the following commands in
Configure mode:
Configure IPX Interfaces for a VLAN
You can configure one IPX interface per VLAN.
Configure an IPX interface to a physi-
cal port. interface create ipx <InterfaceName>
address-mask <ipxAddr-mask> port <port>