Cabletron Systems FLIU-1, Руководство по установке, Страница: 30 / 40

Page 3 - 4
INSTALLING SYSTEM SOFTWARE
Change
This command lets you change information Þelds of any wireless
transceiver. Choosing
Change displays Þelds for Wireless
Transceiver number (i.e., 1, 2, 3, etc.), name, and serial number. To
change the information, enter the Wireless Transceiver number,
and press
<Enter> .
Use the Up Arrow and Down Arrow keys to select a Þeld to
change... then [make the change], [select the next Þeld] and press
<Enter> to accept the changes.
Save
This command saves the changes to the Wireless Transceiver List
to the Þle XCVRS.CNF in the same directory as the conÞguration
utility.
Reload
This command reloads the Wireless Transceiver List from the
XCVRS.CNF Þle, enabling you to modify the Þle since the last time
you saved it.
End
This command exits the current screen. Press <F10> to exit the
conÞguration program.
If you are not installing SNMP management, you can exit the
program at this time by pressing
<F10>
. You can install the
conÞgured software in the wireless hub at this time. Insert the
conÞgured diskette into the wireless hub disk drive and restart the
wireless hub. The hub will boot and be ready to use in
approximately two minutes.
NOTE:
If you are installing SNMP management, you must deÞne the
Wireless HubÕs Community List . Press Page Down to
access the
DeÞne Wireless HubÕs Community List
screen.
Then, use the procedure on the following pages.