Cabletron Systems FLIU-1, Руководство по установке

Страница: 28 / 40

Page 3 - 2
INSTALLING SYSTEM SOFTWARE
¥ The
DeÞne Hub Parameters
screen will appear. This screen
contains three Þelds that are used for setting the LANÕs
Internet Protocol parameters.
IP Address
The wireless hubÕs Internet Protocol Address x.x.x.x where x is a
one to three digit decimal number in the range 0 to 255. If you
donÕt use TCP/IP and you donÕt have an assigned IP address, you
may use the address 192.0.2.n, which is a test address (n is any
number from 1 to 255, inclusive).
Default Gateway
An address in the form x.x.x.x as above, deÞning a gateway, or
bridge to another network. If your FreeLINK LAN will not access
another network, enter 0.0.0.0 as the Default Gateway address.
Network Mask
A number in x.x.x.x notation deÞning a subnetwork. If you are not
using a subnetted network, leave the default set to 0.0.0.0.
When you have Þnished setting these parameters, press <Enter> to
move to the Select Modem Speed screen.
¥ You use the
Select Modem Speed
screen to set the wireless
hubÕs serial port parameters. The serial port is used for out-of-
band network management. The modem may actually be a
Null Modem (crossed over cable), from the RS232 serial port on
the network management computer.
NOTE:
You can press F1 to display more information about any screen,
or press F2 to access general help. Use the Page Up and Page
Down
keys to move between pages. Press
F10
to exit the
conÞguration program.
NOTE:
The following Þelds are used for SNMP management. If you
are not using SNMP management, these Þelds can be set to
the default values.