Cabletron Systems FLIU-1, Руководство по установке

Страница: 19 / 40

SITE PLANNING AND INSTALLATION
Page 2 - 3
The single port interface unit uses a single RJ-45 connector (see
Figure 2-3, below); the multi-user interface unit will accept eight
RJ-45 Ethernet cables but has no AUI port. Use standard, straight-
through RJ-45 cables to connect the interface units to workstation
Ethernet adapters.
Figure 2-3. Connecting FLIU-1 Transceiver/Interface Unit
After connecting the data interface cables, attach the power cord to
the interface module, and plug it into a 110 Volt outlet.
2.4 TRANSCEIVER SERIAL NUMBERS
As you set up each transceiver, you should record the last six digits
of the serial number imprinted on the bottom of the transceiver
(see Figure 2-4).
You will need the transceiver serial numbers to conÞgure the
Wireless LAN software for the wireless hub. A convenient serial
number record sheet is included in Appendix B.
RJ-45
Twisted Pair
Cable
RJ-45 port
AUI
Antenna
AUI Cable
Antenna
Cable
Power Connection
(on rear panel)
FLIU-1
FreeLink.Ch2.fixed Page 3 Wednesday, April 19, 2000 3:59 PM