Cabletron Systems FLIU-1, Руководство по установке

Страница: 29 / 40

INSTALLING SYSTEM SOFTWARE
Page 3 - 3
The available baud rates are: 100, 300, 1200, 2400, 4800, 9600,
and 19,200. Use the
Up Arrow and Down Arrow keys to
highlight a baud rate. After you have selected the baud rate,
press
<Enter> to proceed to the Transceiver Names/Ethernet
Addresses screen.
¥ The Transceiver Names/Ethernet Addresses screen lets you
create, view, and maintain the wireless hubÕs internal list of
wireless transceivers. Before the hub will accept data from a
transceiver, the hub checks this list to determine if the
transceiver has access privileges.
To add a transceiver use the Add command. To display a listing of
the existing transceivers, use the
List
command. Use the
Left
Arrow and Right Arrow keys to move between the screenÕs seven
commands. These commands are deÞned below:
List
This command displays a list of the names and serial numbers of
the wireless transceivers conÞgured on your network.
Add
This command lets you add a wireless transceiver to your
network. Add displays three Þelds: Next Available Transceiver
Number, Name Field, and Serial Number Field.
Delete
This command lets you delete a wireless transceiver from your
network. Choosing
Delete displays a box with a Þeld for a wireless
transceiver number. To delete a wireless transceiver, enter its
Transceiver Number (i.e., 1, 2, 3, etc.) and press
<Enter> . The
software will then display a box with the transceiverÕs serial
number, and ask for conÞrmation before the transceiver is deleted.
Press
<Enter> after conÞrmation to delete your selection.
NOTE:
When entering transceiver serial numbers, use the last six
digits of the serial number on the bottom of the Wireless
Transceiver Antenna. After entering the serial numbers,
always save the new list using the
Save command.