CHAPTER 5: LOCAL MANAGEMENT
Page 5-16
EMME USER’S GUIDE
4. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER.
If the time entered was a valid format, the Event Message Line at the top
of the screen displays “SAVED OK.” If the entry was not valid, Local
Management does not alter the current value and refreshes the System
Time field with the previous value.
5.8.4 Setting the IP Address
The IP Address table allows you to assign IP addresses to each of the four
EMME interfaces. These four interfaces keep the packet traffic between
devices for a specific channel’s subnetwork on that subnetwork, and only
forwards packets meant for devices on another channel and its related
subnetwork(s). This increases the number of segments that can be
connected to one EMME-controlled FNB supporting MMAC.
Before you configure the IP Address Table, check that your configuration
correctly establishes your repeater MIMs for either Channel B, C, or as
stand-alones (refer to your repeater MIM documentation if necessary).
To set the EMME IP address, perform the following steps;
1. Use the arrow keys to highlight the appropriate IP address field.
2. Enter the IP address into this field using Decimal Dotted Notation
(DDN) format.
For example: 134.141.25.17
3. Press ENTER. If the IP Address entered was a valid format, the cursor
returns to the beginning of the IP Address field. If the entry was not
valid, the Event Message Line displays “INVALID IP ADDRESS OR
FORMAT ENTERED.” Local Management does not alter the current
value and refreshes the IP Address field with the previous value.
4. Repeat steps 1–3 to enter each Interface’s IP address.
5. Use the arrow keys to highlight the SAVE command.
6. Press ENTER. The Event Message Line at the top of the screen
displays “SAVED OK.”
