PVC Addendum to the 9A686-04/9A656-04 Configuration Guide
9033126-01
Page 26 of 43
Step 11. Set ATM traffic descriptor parameter 3.
This section describes how to set the third traffic parameter for this traffic descriptor. Traffic Parameter 3
is used to determine the Maximum Burst Size (MBS) that this traffic descriptor will use. Refer to
Figure 15
.
Figure 15 Setting Traffic Parameter 3
Figure 15
contains three callouts, which are defined as follows:
A
Displays the MIB command used to view this information (atmTrafficDescrParam3) and the OID string
used to access this command (1.3.6.1.2.1.37.1.5.1.5).
!
CAUTION
Depending on the Traffic Descriptor Type selected, the user MUST assign values to the
applicable number of parameters required by the traffic descriptor type. For example,
this traffic descriptor type, “atmNoCpScr” requires parameters 1 through 3 to be
configured. If these parameters are not set, the traffic descriptor will NOT operate
properly. Refer back to
Table 8
for a list of how many parameters each traffic descriptor
requires, and what each parameter configures.
B
A
C
