Cabletron Systems 6H133-37, Руководство пользователя

Страница: 144 / 204

Chapter 5: Local Management
5-94 6H123-50 and 6H133-37 User’s Guide
MODE DESIRED OPER. (Selectable)
This field steps through the following operating mode options: Auto-Neg
(Auto Negotiation), 10Base-T, and 100Base-TX.
• When Auto-Neg. is selected, the port Auto-Negotiates with the device
to which it is attached to determine its Operating Mode (10 Mbps or
100 Mbps).
• When 10Base-T is selected, the port is forced to operate in standard
Ethernet mode (10 Mbps) only.
• When 100Base-TX is selected, the port is forced to operate in Fast
Ethernet mode (100 Mbps) only.
To set the port operating mode, refer to Section 5.27.1 .
MODE PORT STAT. (Toggle)
Used to enable (turn on) or disable (turn off) the port. To set the port to
operating mode, refer to
Section 5.27.2 .
SET ALL PORTS (Selectable)
Used to select operating mode for all the ports on the connector
simultaneously. This field steps through the following selections:
Auto-Neg., 10Base T, and 100Base-TX. To set all networks to the same
operating mode, refer to
Section 5.27.3 .
CONNECTOR # (Selectable)
Selects the front panel connector to which the settings will be applied.
5.27.1 Setting the Port Operating Mode
To set the operating mode for one or more network ports, proceed as
follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the appropriate connector number.
3. Use the arrow keys to highlight the MODE DESIRED OPER. field
of the network being configured.
4. Use the SPACE bar to step to the appropriate Operating Mode
(Auto-Neg, 10Base-T, or 100Base-TX).
5. If setting the operating mode on other ports, repeat steps 3 and 4 for
each one and then proceed to step 6.