Cabletron Systems 6H133-37, Руководство пользователя

Страница: 122 / 204

Chapter 5: Local Management
5-72 6H123-50 and 6H133-37 User’s Guide
Peak Switch Utilization (Read-Only)
Shows the peak percentage of maximum switching capacity, since last
reset.
Reset Peak Switch Utilization (Toggle)
Enables the user to reset the Peak Switch Utilization field. The switch
may be set to either YES or NO as described in
Section 5.20.1 . YES resets
the Peak Switch Utilization field to the current system traffic.
5.20.1 Setting the Reset Peak Utilization
To set the Reset Peak Utilization field to YES or NO, proceed as follows:
1. Use the arrow keys to highlight the Reset Peak Utilization field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrows keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays.
5.21 HIGH SPEED INTERFACE CONFIGURATION
SCREEN (6H123-50 ONLY)
To access the High Speed Interface Configuration Menu screen from the
Device Specific Configuration Menu screen, use the arrow keys to
highlight the HIGH SPEED INTERFACE CONFIGURATION menu
item and press ENTER. The High Speed Interface Configuration
screen,
Figure 5-27 , displays.
NOTE
When the HIGH SPEED CONFIGURATION MENU item is
selected for the 6H133-37, the applicable HSIM Setup screen
displays. Refer to the HSIM user’s guide to set operating
parameters for the HSIM installed in the 6H133-37.
NOTE
The High Speed Interface Configuration screen, Figure 5-27 ,
applies only to slots 5 and 6 of the 6H123-50. This screen
supports the FE-100TX, FE-100FX, and FE-100F3 Fast
Ethernet Interface Modules that operate at 100 Mbps.