Cabletron Systems 6H133-37, Руководство пользователя

Страница: 103 / 204

General Configuration Screen
6H123-50 and 6H133-37 User’s Guide 5-53
4. Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
5.15.10 Setting the Management Mode
To set the Management mode, perform the following steps:
1. Use the arrow keys to highlight the Management Mode field:
2. Use the SPACE bar to toggle the options DISTRIBUTED or STAND
ALONE until the desired mode displays.
3. Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown back in
Figure 5-19 displays.
4. Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
NOTE
Upon saving the new operational mode, the module reboots.
If the 6H123-50 and 6H133-37 have been set to 802.1Q
SWITCHING, refer to the
Port Based VLAN User’s Guide to
configure the devices for this type of operation.
If the 6H123-50 and 6H133-37 have been set to SECURE
FAST VLAN, refer to your SecureFast documentation set to
configure the devices for this type of operation.
NOTE
Upon saving the new Management Mode, the module will
reboot.
If the module will be set to STAND ALONE, ensure the
following procedures have been completed:
The module has been assigned a unique IP address that has
been saved (i.e., the module has rebooted and the new IP
address is active.)
The module has been assigned SNMP community names from
the module SNMP Community Names screen (
Section 5.16 ).
In STAND ALONE management mode, the module does not
use the community names of the 6C105 chassis.