Cabletron Systems 2000, Руководство по началу работы, Страница: 76 / 92

Chapter 3: Software Installation and Setup
76 SmartSwitch Router 2000 Getting Started Guide
Note: You also can save active changes to the Startup configuration file from within
Configure mode by entering the
save startup command.
The new configuration changes are added to the Startup configuration file stored in the
SSR 2000’s boot flash.
Viewing the Current Configuration
If you want to view the current configuration:
1. Ensure that you are in Enable mode by entering the enable command in the CLI.
2. Enter the following command to display the status of each command line:
The CLI displays the active configuration file with the following possible annotations:
– Commands without errors are displayed without any annotation.
– Commands with errors are annotated with an “E”.
– If a particular command has been applied such that it can be expanded on
additional interfaces/modules, then it is annotated with a “P”. For example, if you
enabled stp on all ports in the current system, however, the SSR contains only 1
module, then that particular command could be expanded at a later date when
more modules have been added to the SSR.
A command like stp enable et.*.* would be displayed as follows:
indicating that it is only partially applied. If you add more modules to the SSR at
a later date and then update the configuration file to encompass all of the available
modules in the SSR, then the “P:” portion of the above command line would
disappear when displaying this configuration file.
If a potentially partial command, which was originally configured to encompass
all of the available modules on the SSR, becomes only partially activated (after a
hotswap or some such chassis reconfiguration), then the status of that command
line will automatically change to indicate a partial completion status, complete
with “P:”.
Note: Commands with no annotation or annotated with a “P:” are not in error.
system show active-config
P: stp enable et.*.*