Cabletron Systems 2000, Руководство по началу работы, Страница: 51 / 92

SmartSwitch Router 2000 Getting Started Guide 51
Chapter 2: Hardware Installation
2. Make sure the TXD signals from the SSR 2000 emerge as RXD signals on the
management console and the TXD signals from the management console emerge as
RXD signals on the SSR 2000.
3. After ensuring that the pin assignments on both ends of the connection are correct,
plug the appropriate end of the connection into the SSR 2000’s RJ-45 10/100Base-TX
port.
4. Plug the other end of the connection into the management console’s port.
5. When you are ready to configure the SSR 2000 using CoreWatch or SNMP, use
procedures in
Chapter 4 , “Installing and Starting Cabletron CoreWatch” on page 77 to
start an SNMP or CoreWatch management session.
Attaching Port Cables
The following sections describe how to connect the SSR 2000 to your network.
10/100BASE-TX Expansion Module
Figure 15 illustrates plugging your 10Base-T or 100Base-TX cable into a 10/100BASE-TX
port. The procedure following the figure explains how to set up and insert the cable.
RXD (receive data) 6 TXD (transmit data)
Unused 7 Unused
Unused 8 Unused
a. The right hand column pin assignments are for the RJ-45 connector on the SSR 2000. Thus, pin 1 (TXD
or “transmit data”) must emerge on the management console’s end of the connection as RXD (“receive
data”) and so on.
Table 17. RJ-45 connector pin assignments (Continued)
Signal (SSR 2000 port) Pin Signal (management console port)