8
8
4
Operation
4.1 General Settings
Activate the peel-off mode in the software.
In direct programming use the "P" command.
Programming Manual of the printer.
Configure the peel-off parameters.
i
Note!
The peel-off parameters are only accessible with a peel-off adapter
or present sensor only.
On the back side of the modules there is a jumper system with 4 possible
jumper settings.
For PS5 set the jumper to JP1 or JP2 to select the mode.
For PS6, PS6V and PS8 the jumper must remain at position JP4
For PS9 the jumper must remain at position JP1
