12
12
4.3 Present Sensor PS6
PS6 can be operated in two different modes.
The operating mode depends on external circuit at the peripheral interface.
The jumper must be at position JP4.
Figure 8 Jumper at position
JP4
4.3.1 Automatic Mode
The present sensor is installed without external circuit.
Send a print job.
The first label will be printed an transported to the peel position.
Remove the label.
The next label will be printed an transported to the peel position.
4.3.2
Label on Demand Mode
To start a peel-off cycle the signal
XSTART
must be sent from an external
control.
For that mode pin 13 (STA) must be connected with pin 12 (GND).
Send a print job.
Activate
XSTART
.
The first label will be printed an transported to the peel position.
Remove the label.
Activate
XSTART
to start the next cycle.
