A2+/A4+/A6+/A8+
Cleaning and basic maintenance
Edition 5/06
Operating Instructions
29
8.7
Replacing the printhead
The printhead of the label printer can be replaced without the need for fine adjustment. The printhead
must be replaced if worn or when switching to a printhead with higher or lower resolution. For better dif-
ferentiation, the print heads have a label stating the printer type and resolution.
Fig. 16:
Cleaning the label sensor
1. Turn lever (1) counterclockwise to lift the
printhead.
2. Remove labels and transfer ribbon from the
printer.
3. Remove hexagonal wrench (5) from its
retainer.
4. Press the latch (3) and slowly pull label sen-
sor outward via the tab (4). Ensure that the
label sensor cable is not tensioned by this.
5. Clean label sensor and sensor units (2) with
brush or cotton swab soaked in pure alcohol.
6. Push label sensor back via tab (3) and set it
(see ”6.1.4” on page 18).
7. Push hexagonal wrench (4) into retainer.
8. Reload labels and transfer ribbon (see ”6.1”
on page 16).
1
2
3
4
5
Fig. 17:
Structure of the printhead
1
Head plate
2
Plug connection
3
Plug connection
4
Screw
5
Printing line
6
Pins
7
Printhead
1
2
3
4
6
7
4
6
5
The printhead (8) is preinstalled on a head plate (1) and precisely aligned at the factory. Do not loosen
the screws (4) under any circumstances.
