A2+/A4+/A6+/A8+
Loading media
Edition 5/06
Operating Instructions
17
6.1.2
Positioning the label roll on the roll retainer
Fig. 5:
Loading labels from a roll
1. Open cover (10).
2. Loosen knurled screw (1) and swivel guide (2) upward and push it all the way out.
3. Remove core adapter (4) for label rolls with a core diameter
≤
75 mm (see ”6.1.1” on page 16).
4. Load label roll on the roll retainer in such a way that the labels can be inserted into the printhead in
the right position. The printing side of the labels must be visible from above.
5. Supplying longer label strips:
For Peel-Off or Rewind mode: approx. 60 cm
For Tear-Off mode: approx. 40 cm
6. Push label roll until it contacts the housing wall.
7. Swivel guide (2) downward onto the roll retainer (3) and push it against the label roll so that the roll
is braked slightly while supplying media.
8. Tighten knurled screw (1).
6.1.3
Inserting a label strip into the printhead
1. Turn lever (9) counterclockwise to lift the printhead.
2. Push guide ring on axis (6) all the way out.
3. Guide label strip to the print unit above the internal rewinder (5).
4. Guide label strips below the axis (6) and through the label sensor (7) in such a way that it exits the
print unit between the printhead and the print roller.
5. Push guide ring on axis (6) against the outer edge of the label strip.
1
2
3
4
5
6
7
10
9
8
