C2R Colibri 5 30-001, Руководство пользователя

Страница: 152 / 168

Colibri serie 5 : User’s guide
© 2000-2008 C2R Technologie, Sarl. All rights reserved.
152 152
Rev. C

Are enabled in the imager or in the decoder to which the imager connects.
Is the bar code displayed but not entered?
The bar code is displayed on the host device correctly, but you still have to press a key to enter it
(the Enter/Return key or the Tab key, for example).
You need to program a suffix. Programming a suffix enables the imager to output the bar code
data plus the key you need (such as “CR”) to enter the data into your application. Refer to
"Prefix/Suffix Overview" on page 47 for further information.
Does the imager read the bar code incorrectly?
If the imager reads a bar code, but the data is not displayed correctly on the host screen:

The imager may not be programmed for the appropriate terminal interface. For
example, you scan “12345” and the host displays “@es%.”
Reprogram the imager with the correct Plug and Play or Terminal selection bar code. See Chapter
2 and Chapter 3

The imager may not be programmed to output your bar code data properly. For
example, you scan “12345” and the host displays “A12345B.”
Reprogram the imager with the proper symbology selections. See Chapter 7.
The imager won‟t read your bar code at all.

Scan the sample bar codes in the back of this manual. If the imager reads the sample
bar codes, check that your bar code is readable. Verify that your bar code symbology is enabled
(see Chapter 7).

If the imager still can‟t read the sample bar codes, scan "All Symbologies" on page 57.
If you aren‟t sure what programming options have been set in the imager, or if you want the
factory default settings restored, scan Standard Product Default Settings on page 123.