- 27 -
NOTE
The air source needs to be equipped by the user. Air volume: not less than
0.9m
3
/min, pressure 1.0mpa.
Inverter debugging
Here only lists the parameters used in the communication debugging of the inverter. In case of other
faults or problems with the inverter, please refer to the inverter manual or ask a professional. The
inverter panel is shown in Figure 7-1.
WARNING!
1. Please turn off the power for 5 minutes before maintenance and inspection.
2. Please read the manual carefully before operation, otherwise it may cause
electric shock or injury.
Setting and changing method of function parameters
①
.
Press the MODE key 5 times to select the function setting mode;
②
.
Press the up key to change the parameter No.
③
.
Press the SET key to display the data
of the currently selected parameter
(flashing state);
④
.
Press the up key to change the
displayed data (flashing state);
⑤
.
Press the SET button again to set the
data;
⑥
.
After finishing the data setting, press
the MODE key twice to enter the
running preparation state.
Figure 7-1 Inverter panel
