- 26 -
[1: Test step]: Click this button to jump to the [Test step] interface to view the test operation steps;
[2: Feeding step]: Click this button to jump to the [Feeding step] interface to view the test loading
operation steps;
[3: Unloading step]: Click this button to jump to the [Unloading step] interface to view the test
unloading operation steps;
[4: Methods of pressure correction]: Click this button to jump to the [Help-Pressure Correction Table]
interface to view the pressure correction method;
[5: Methods of air pump discharge water]: Click this button to jump to the [Methods of air pump
discharge water] interface to view the air pump drain method. It is required that the air pump should
be drained every week under the normal operation of the instrument;
[6: Description of device status code]: Click this button to jump to the [Description of device status
code] interface to view the device status code description, or refer to Appendix 2 of this manual to
view the device status code;
[Return]: Click this button to return to the [Help & Settings] interface.
VII.
Installation and debugging
Installation
1.
Place the instrument steadily on the ground, and adjust the level of the upper plane on the trolley.
After adjustment, fix the instrument to the ground. Since the instrument is often in a state of
vibration, be sure to make the ground shockproof.
2.
Connect the plug of the power cord to the instrument, and then connect the power cord to the
AC220V/50Hz power supply.
3.
Connect the air inlet of the instrument to the air pump or the air inlet pipe. Inlet pressure
requirement: 0.6-0.8 MPa.
4.
Check the instrument for loose bolts and abnormal phenomena. If so, please improve it in time.
5.
Test run of the instrument without load.
