8.
44
9-7 Brake cable maintenance :
※
Scissors x 1pcs
※
Hex wrench #10 x 1pcs
1.Refer to 3-1 Powering off the battery to power off the scooter.
2.Refer to 3-2 Battery removal to remove the battery connector.
4-4 Panel wiring instruction to remove the panel wiring.
4-6 Steering cover maintenance to remove the cover.
5-1 Front slanting maintenance to remove the internal connector.
6-3 Front shroud upper cover maintenance to remove the upper cover.
7-4 Main controller maintenance to remove all connectors.
8-6 Brake handle maintenance to remove the brake handle.
8-7 Rear cover maintenance to remove the tail light connector.
3.Starting from the head, the brake cable goes to the left of the steering and cuts the upper fixed
strap (x 1pcs).
4.The trace extends to the right side of the lower center bar bead-bowl nut and cuts the upper fixed
strap (x 1pcs).
5.The trace extends to the right side of the lower front frame and cuts the upper fixed strap (x 1pcs).
6.The brake trace goes separately from the sides of the frame to connect the left/right rear wheel
brake disks and cuts the upper fixed strap ( x 4pcs).
7.Loosen the left/right brake adjustment screws.
8.Remove the left/right brake cable and spring.
※
The entire brake cable can now be removed.
※
Please follow the above steps in reverse for reassembly and replacement.
※
If the scooter's manual brake fails, please check the brake disk first. If there is no
abnormality, check or replace the brake cable.
※
When the brake cable is reassembled or replaced, be sure to retie the cut-open fixing
straps as described above and fix it without tightening too tightly.
※
Please let the brake line go to the right side of the scooter, and the main line to the left
side; the brake cable must be fixed to the right side of the frame to prevent interference.
