※
Step 3. The front wheel connecting lever is connected to the bottom of the center bar,
which must be removed. If it is not disassembled, the center bar cannot be removed
due to the front wheel suspension.
※
Step 7. To remove the center bar bead-bowl set, a water channel clamp must be used.
※
A set of steel beads is located at the bottom of the center bar. Please pay attention to
prevent falling and loss when disassembling/reassembling. The beads should be placed
upwards.
※
If the steel bead set needs to be reassembled or replaced, it is recommended to apply
a small amount of butter to the upper and lower steel bead sets for lubrication.
※
When removing the center bar, lift the front end of the whole scooter. This should be
done with two or more people, even with the aid of a mechanical hoister.
33
6-5 Center bar maintenance :
※
Hex wrench 10 x 1pcs
※
Hex wrench 8 x 2pcs
※
Hex wrench 13 x 1pcs
1.Refer to 3-1 Powering off the battery to power off the scooter.
2.Please refer to 6-1 Steering frame repair to remove the Steering.
6-3 Front shroud upper cover maintenance to remove the front shroud upper cover.
3.Remove the coupling nut at the front wheel connecting rod and the bottom of the center bar.
4.Remove the clamp screws.
5.Remove the fixing screws.
6.Remove the lower steering connector.
7.Remove the center bar bead-bowl nut.
8.Remove the entire set of bead-bowls.
9.Remove the lower center bar and the steel bead set.
※
Please follow the above steps in reverse for reassembly and replacement.
3.
6.
8.
9.
5.
4.
160+-16kgf-cm
150+-15kgf-cm
7.
250+-25kgf-cm
