※
The vibration of the scooter is mainly absorbed by the shock absorber. If the vibrations
are too large, it may be related to the shock absorber.
※
The shock absorber may make abnormal sounds when running. This is mainly due to
the collision of the shock absorber with the leaf spring, the frame, or the shaft, the damage
or loosening of the rubber pad, or the deformation of the shock absorber dust cylinder.
Please replace it with a new one.
※
When steering, the incline of the scooter shroud is obviously increased and may even
cause sideslip. This is mainly because the damping force of the shock absorber is too
small to effectively suppress the compression of the spring. Please replace it with a new
one.
※
When reassembling the shock absorber spring, the larger number of turns should face
upwards, and the smaller number of turns should face downward.
5.
4.
100+-10kgf-cm
100+-10kgf-cm
42
9-5 Front shock absorber maintenance :
9-6 Main cable maintenance :
※
Scissors x 1pcs
1.Refer to 3-1 Powering off the battery to power off The scooter.
2.Refer to 3-2 Battery removal to remove the battery connector.
4-4 Panel wiring instruction to remove the panel wiring
4-6 Steering cover maintenance to remove the cover.
5-1 Front slanting maintenance to remove the internal connector.
6-3 Front shroud upper cover maintenance to remove the upper cover.
7-4 Main controller maintenance to remove all connectors.
8-7 Rear cover maintenance to remove the tail-light connector.
3.The main line goes to the front of the steering and cuts the upper strap (x 1pcs).
4.The trace extends to the lower center bar bead-bowl nut and cuts the upper band (x 1pcs).
5.Find the relevant connector on the front of the frame and cut the strap (2pcs).
※
Upper strap fastening : power connector / charging base connector.
※
Lower strap fastening : headlight / steering light connector.
※
Hex wrench 17 x 2pcs
1.Refer to 3-1 Powering off the battery to power off the scooter.
2.Refer to 6-3 Front shroud upper cover maintenance to remove the upper cover.
3.Remove the rear shock absorber upper fixing screw set (M10 x 67L x 1pcs).
4.Remove the rear shock absorber lower fixing screw set (M10 x 45L x 1pcs).
5.The entire rear shock absorber
set can now be removed.
※
The left / right rear shock absorber
can be disassembled in the same
way.
※
Please follow the above steps
in reverse for reassembly and
replacement.
