To return the SmartFeed Pro to regular operating mode:
Note: If you disengage the training latch on the SmartFeed machine, you must also
switch SmartFeed into normal operating mode online.
1. Tap “Unlock Door” in Control Feed. If SmartFeed is powered off, you will have to
manually unlock the latch (see
Section 2.2
)
2. Push the gate as far open as it will go.
3. Return the orange training latch to its holder.
4. Allow the gate to close until the latch engages the gate-height adjustment pin.
2.4.
Adjusting the SmartFeed Height
2.4.1 -
SmartFeed can be adjusted to accommodate a wide range of animal sizes.
Adjusting the height requires at least two people. To adjust the full height of the front
follow these steps:
Figure 9) Loosen four bolts to raise/lower the front of SmartFeed
Caution: At least two people are required to adjust the height of the gate system.
The only equipment that is holding the gate at its height are the four bolts shown in
Figure 9. Once these bolts are removed, the whole gate *will* fall (and is heavy), so
be sure to have support and/or multiple people to hold it in place.
13
