BYOC Overdrive 2, Инструкции к набору

Страница: 34 / 37

produce more gain and volume. The drawback of this is that the boost will become
dirtier as you increase the gain. This mod will work with both the standard and
MOSFET build specs. Try a 100ohm or 220ohm resistor. You can even use a jumper for
maximum gain.
2. You can also make the standard silicon boost louder and dirtier by increasing the value
of the 10k resistor highlighted in yellow. Try a 15k resistor. This mod will not work with
MOSFET build specs.
Modifying for Bass Guitar - 1. Make the 22n input cap larger to allow more low end
signal through. Try a 100n or .1uf.
2. Make the mids caps larger for fuller bottom end. The 47n highlighted in red would
be your center position (position2 on the toggle switch) cap. Try a 100n or .1uf cap here.
The 47n cap highlighted in yellow gets put in parallel with the other 47n cap when the
toggle switch is to the left(position 1). Try a 100n or .1uf cap here. And the 150n cap