STEP 9:
Standard specs:
Add the MPSA18 transistors to the spaces highligted in RED. Be sure
to match up the flat side of the transistor with the flat side on the layout. The spaces
highlighted in yellow are for MOSFET clipping transistors. If you are using the clipping
LEDs, do not used the MOSFET clipping transistors. You cannot use both at the same
time.
MOSFET specs:
Add the BS170 transistors to all the spaces highlighted in RED and
YELLOW.
Be sure to put the BS170's in backwards from the PCB layout.
Do not add
the clipping LEDs if you will be using clipping MOSFETS highlighted in yellow.
Содержание Overdrive 2
