GB
Page 28 of 62
INSTRUCTION, USE AND
MAINTENANCE MANUAL
• Press on the adhesive weights icons (
Fig. 39 ref. 4
)
or clip weights icons (
Fig. 39 ref. 5
) (according to
where you want to apply them), to automatically
set the appropriate balancing program (only with
touch screen).
With this mode only the 11 standard programs can
be selected (DYN, ALU-S, ALU-S1, ALU-S2, STAT,
STAT-1, STAT-2, ALU-1, ALU-2, ALU-3, ALU-4).
- After the balancing program modification, simply
press
to carry out the recalculation of the
weights and the new fitting points.
Proceed as described in Para 14.5.
•
Procedure for electronic automatic RUN-OUT (rim
inner side).
The electronic RUN-OUT measuring device is useful
to check if the rim has some imperfections.
MAKE SURE THE ICON
IN THE OPTIONS MENU IS ENA-
BLED (SEE PAR. 15.1).
In order to display the eccentricity graph/wheel
imperfection screen page, proceed as described
hereafter:
- perform the wheel spin by closing the guard.
After executing the spin of the tyre with any kind of
program, the weights fitting page is displayed.
Here follows an example of the mentioned page:
By pressing the button
(if on this screen
page), it is possible to display the eccentricity graph
reported here as follows.
Fig. 38
1
2
3
6
1 – Fundamental sine wave(yellow-coloured-
graph)
2 – Graph of detected eccentricity (orange)
3 – Slider that indicates the current position of
the wheel ("12 o'clock") (blue)
4 – Value in mm of the highest peak of rim de-
tected eccentricity
5 – Value in mm of eccentricity of the rim at the
current position
6 – Value in mm of the lowest peak of rim de-
tected eccentricity
7 – Graph deleting button
4
5
7
The orange graph (
Fig. 38 ref. 2
) represents exactly
the geometric shape of the rim. The more the circle is
round and linear, the more the graph is flat, unlike the
more the circle has deficiencies, the more the graph
is large.
You can follow the eccentricity in the graph by manu-
ally turning the rim, the blue-coloured-slider (
Fig. 38
ref. 3
), indicates the position of the rim in "12 o'clock"
position.
The three numeric values (
Fig. 38 ref. 4-5-6
), ex-
pressed in mm, indicate respectively the highest
peak, the eccentricity in the current position and rim
minimum peak.
The graph can be erased with push button (
Fig. 38
ref. 7
).
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
1297-M021-1_B
