INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 27 of 62
- At the end press push button
and
.
IN CASE OF BALANCING OF
WHEELS HAVING THE SAME
CHARACTERISTICS AND DIMEN-
SION SIMPLY:
- GO TO SCREEN PAGE (FIG. 34
OR 36) (SCREEN PAGE WHERE
ARE THE DISPLAYED THE
MEASUREMENTS ACQUIRED
BY THE MACHINE/MODIFIED BY
THE OPERATOR),
- FIT THE WHEELS TO BALANCE
ON THE MACHINE,
- START THE DETECTION OF THE
UNBALANCE BY CLOSING THE
GUARD.
IN THIS WAY THE MACHINE WILL
USE THE WEIGHT FITTING MEAS-
UREMENTS IN FIG. 34 OR 36 FOR
ALL THE WHEELS TO BALANCE.
IF THE MEASUREMENT NEED TO
BE RESET, GO TO “HOME” PAGE
AND PERFORM THE AUTOMATIC
SPIN AS DESCRIBED IN PAR.
14.2.1.
IN CASE THE “WEIGHTS HID-
DEN BEHIND SPOKES” OPTION
IS ENABLED (AUTOMATIC), THE
WHEEL STOPS WITH THE LASER
INDICATING THE POSITION OF
THE 1
ST
WEIGHT TO FIT AND ON
MONITOR IS DISPLAYED THE
NEXT SCREEN PAGE:
AFTER THE FITTING OF THE 1
ST
WEIGHT BEHIND THE SPOKE,
SIMPLY PRESS THE
BUT-
TON TO POSITION THE WHEEL
AND THE LASER FOR THE FIT-
TING OF THE 2ND WEIGHT.
AT THE END JUST PRESS
TO RETURN TO THE PREVIOUS
SCREEN PAGE AND FOR BEING
ABLE TO FIT THE FOLLOWING
WEIGHT ON THE WHEEL INNER
SIDE (POSITION INDICATED BY
THE LASER AGAIN) (SEE FIG. 41).
AT THE END PERFORM A TESTING
SPIN BY CLOSING THE PROTEC-
TION GUARD.
- The balancing program can be changed in 2 possible
ways:
• press program icon (
Fig. 39 ref. 3
) to display the
following screen page for programs selection:
Press directly on the wished mode icon in order to
select it.
1297-M021-1_B
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
