GB
Page 56 of 68
INSTRUCTION, USE AND
MAINTENANCE MANUAL
Place the gauge (
Fig. 67 ref. 1
) on the mandrel flange
(
Fig. 67 ref. 2
).
Fig. 67
2
1
The following screen will appear on the monitor to
indicate the measured values:
2
1
Fig.
_
68
- The value next to the symbol "scale" (
Fig. 68 ref. 1)
(236 mm for screw mandrel or 256 mm for pneu-
matic mandrel) must be equal to the value positioned
above the gauge (
Fig. 68 ref. 2
) ± 1 mm.
IF THE MEASUREMENT GAUGE
IS NOT EXACTLY POSITIONED
ALONG THE UPPER EDGE OF THE
FLANGE AND CONSEQUENTLY IF
THE DISTANCE MEASUREMENT IS
NOT 236 MM (FOR SCREW MAN-
DREL) OR 256 MM (FOR PNEU-
MATIC MANDREL), WHEN THE
MEASUREMENT IS CONFIRMED,
THE PROGRAM WILL NOT PASS
ON TO THE NEXT STAGE. TRY
REPOSITIONING THE GAUGE FER-
RULE ALONG THE UPPER EDGE
OF THE FLANGE AND, IF THE
MEASUREMENT CONTINUES NOT
TO BE BETWEEN 236 MM (FOR
SCREW MANDREL) OR 256 MM
(FOR PNEUMATIC MANDREL) AND
THE PROGRAM DOES NOT PASS
ON TO THE NEXT CALIBRATION
STAGE, CONTACT THE AFTER-
SALES SERVICE.
- Press push button
.
The following screen will appear on the monitor:
- Place the gauge as shown in the following figure:
- Press push button
. Wait a few seconds until
you see the following screen:
- Place the gauge against the mandrel in the lower part
of the it but on a smaller diameter than before as
indicated on the image on the monitor.
1297-M008-4_B
LIBRAK355 - LIBRAK355P - LIBRAK355S - LIBRAK355PS - LIBRAK355WS - LIBRAK355PWS
