INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 23 of 68
1
2
3
4
Fig. 32
4. Fit the protection cap (
Fig. 33 ref. 1
) in the bush
(
Fig. 33 ref. 2
) and bring everything against the
wheel.
1
2
Fig. 33
Lift the control pedal to close the mandrel and then
clamp the wheel.
Some aluminium wheels, with very high centring, must
be fitted with the cone outside the wheel.
5. Clean the mandrel (
Fig. 34 ref. 1
) before fitting
the wheel.
6. Fit the wheel (
Fig. 34 ref. 3
) with the inside of the
rim towards the wheel balancer, until the wheel is
up against the support flange (
Fig. 34 ref. 2
).
12.2 Fitting of the wheel (
LIBRAK355P -
LIBRAK355PS - LIBRAK355PWS)
Open the pneumatic mandrel
by means of the special
pedal, see
Fig. 31
.
Fig. 31
Open/close the pneumatic
mandrel
Brake the wheel
1. Remove any type of foreign body from the wheel
(
Fig. 32 ref. 3
): pre-existing weights, stones and
mud, and make sure the mandrel (
Fig. 32 ref. 1
)
and the rim centring area are clean before fitting
the wheel on the mandrel.
2. Carefully choose the cone (
Fig. 32 ref. 2
) most suit-
able for the wheel to be balanced. These accessories
must be selected according to the shape of the rim.
Position the wheel (
Fig. 32 ref. 3
), fitting the cone
(
Fig. 32 ref. 2
) on the mandrel (
Fig. 32 ref. 1
): be
careful (otherwise this could seize) until this rests
against the support flange (
Fig. 32 ref. 4
).
3. Fit the wheel with the inner side of the rim towards
the wheel balancer and against the cone.
1297-M008-4_B
LIBRAK355 - LIBRAK355P - LIBRAK355S - LIBRAK355PS - LIBRAK355WS - LIBRAK355PWS
