42
time, the motion indicator LED will blink red continuously. After it stops
blinking, the PIR is active, and any motion that is detected by it will trigger
the capture of photos or videos as programmed in the SETUP Menu.
Be sure you have read the descriptions of the Capture Number, Video
Length, Interval and Sensor Level parameters. Please note, the PIR is
strongly sensitive to ambient temperature. The greater the temperature
difference between the environment and your subject, the farther the
possible sensing distance. The average sensing distance is about 45 ft.
Before leaving the camera unattended, please check for the following:
• Are the batteries or DC power supply inserted/connected with
correct polarity and is the power level is sufficient?
• Does the SD card have sufficient available space and is its write-
protection (lock) switch off?
• Is the Power switch in the ON position? (do not leave it in SETUP).
PLAYING BACK/DELETING THE PHOTOS/
VIDEOS
After you have setup, mounted and activated your Aggressor Wireless
Cam, you will of course be eager to return later and review the images it
has captured for you. There are several different ways to do this:
1) Reviewing Images Remotely via Website/Apps
Please refer to pages 10, 14 and 15 in the Quick Start Guide section at the
front of this manual for details on how to review your camera’s images
online or with our smartphone application.
2) Reviewing Images Directly From the SD Card
This is the most popular method of viewing images. Since unmounting
the camera and taking it to your computer isn’t very convenient, you may
find it easier to just take the card out. By removing the SD card (swapping
it for a new empty card if you like) and taking it to your home or campsite
to view the images by using an SD card “reader”
(user supplied)
connected
to your computer (some computers and TVs have a built in SD card slot),
you can leave the camera in place ready to capture more images. Once
connected, the card reader works the same way as described below-
