22
ON MODE
Anytime after the batteries and SD card have been inserted, you can
switch on the camera. When the power switch is moved to the right
position, the camera will enter into the ON (Live) mode. The motion
indicator LED (
pg. 18, “Front View”
) will blink red for about 10 seconds. This
interval allows time for you to close the Aggressor Wireless Cam’s front
cover, lock it, and leave the monitored area. Once in the ON mode, no
manual controls are needed or possible (the control keys have no effect).
The Aggressor Wireless Cam will take photos or videos automatically
(according to its current parameter settings) when it is triggered by the
PIR sensor’s detection of activity in the area it covers.
You can either move the power switch directly from OFF to ON mode,
or stop at the SETUP position first to change one or more settings, then
move the switch to ON after you have finished doing so.
SETUP MODE
In the SETUP mode you can check and change the settings of the
Aggressor Wireless Cam with the help of its built-in LCD (
or a monitor
connected to the TV out jack
). These settings, found in the SETUP Menu,
let you change the photo or video resolution, interval between photos,
switch the time imprint on, etc. Moving the power switch to the SETUP
position will turn on the LCD display, and you will see an information
screen that shows how many images have been taken, the battery level,
camera or video mode, etc (
Fig. 3
,
pg. 24
).
NOTE: Always move the power switch from
OFF
to
SETUP
mode. It
is possible that the camera could lockup if it is switched from
ON
to
SETUP
mode. If this occurs, simply move the switch to
OFF
and then
push it up to
SETUP
again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in “Parts & Controls”, four of the keys below the LCD
have secondary, “shortcut” functions when the camera is switched to
SETUP mode (but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
