Bush DLED50UHDHDRS, Инструкция по эксплуатации

Страница: 18 / 64

Connections
Connector Type Cables Device
VGA
Connection
(back)
AUDIO IN
PC/YPbPr
Audio
Connection
(back)
YPbPr/PC Audio Cable
HDMI
Connection
(side&back)
SPDIF
SPDIF
(Optical Out)
Connection
(back)
BACK AV
Back AV
(Audio/Video)
Connection
(back)
Audio Video Cable
HEADPHONE
Headphone
Connection
(side)
YPBPR
YPbPr Video
Connection
(back)
PC to YPbPr Connection Cable
USB
Connection
(side)
CI
Connection
(side)
CAM
module
LAN
Ethernet
Connection
(back)
LAN / Ethernet Cable
See the illustrations on the left side.
You can use YPbPr to VGA cable to
enable YPbPr signal via VGA input.
You cannot use VGA and YPbPr at the
same time. To enable PC/YPbPr audio,
you will need to use the back audio
inputs with a YPbPr/PC audio cable
for audio connection. When using the
wall mounting kit (available from a third
party in the market, if not supplied),
we recommend that you plug all your
cables into the back of the TV before
mounting on the wall. Insert or remove
the CI module only when the TV is
SWITCHED OFF. You should refer to
the module instruction manual for
details of the settings. The/Each USB
input of your TV supports devices up
to 500mA. Connecting devices that
have current value above 500mA may
damage your TV. When connecting
equipment using a HDMI cable to your
TV, to guarantee sufficient immunity
against parasitic frequency radiation
and trouble-free transmission of high
definition signals, such as 4K content,
you have to use a high speed shielded
(high grade) HDMI cable with ferrites.
If you want to connect a device
to the TV, make sure that both
the TV and the device are turned off
before making any connection. After
the connection is done, you can turn
on the units and use them.
Connections
Bringing it all together
Connections 16
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,