Busch & Müller 168/35LA-01, Инструкция по эксплуатации

Страница: 26 / 100

26
6.2. Assembly of IQ-XM speed and battery pack
Place the rubber ring 7 of the handlebar bracket 5 around the handlebar. Depending on the handle-
bar diameter, screw the locking screw and the locking knob 8 into the handlebar bracket 5 . Place the
handlebar bracket 5 over the rubber ring 7 with the locking knob 8 facing the seat. Join the legs
underneath the handlebar and fasten them using the locking screw 8 .
!
Please note: The locking knob 8 can be used either as a short or long version. (simply turn as
required)!
Insert the headlight 1 vertically from above into the
headlight bracket 5 in the direction of travel and press down
firmly. It audibly engages in the locking ring 6 . Make sure it
is firmly seated in place. To remove the headlight 1 , turn the
locking ring 6 clockwise, hold the headlight 1 firmly and
pull it upwards. We do not assume any liability in case of drop
damage, e.g. because the headlight
1 was not held in place
while releasing the locking ring 6 . If the assembly situation
on the bicycle only allows the locking knob 8 facing away
from the cyclist, use a screwdriver to unbolt the bracket on the underside of the headlight 1 turn by
180° and then fasten again. The bracket is the headlight 1 component that is screwed into the locking
ring 6 .
The position of the headlight 1 can be changed vertically and horizontally by a few degrees. Vertically,
the slant of the headlight 1 is changed via the slant of the handlebar bracket 5 . For horizontal adjust-
ment, the headlight 1 can be swivelled (to a limited extent) continuously on the rubber ring 7 to the
left or right. In both cases, the locking screw on the bracket must be loosened and securely re-tightened
afterwards once again to ensure that the headlight
1 cannot come loose or move all by itself.
Assembly of handlebar switch using a bracket
Suitable for handlebars of Ø 22 to 32 mm
Attach the handlebar switch 3 to operate the headlight 1 and the high beam function securely and
easily accessible to the handlebar using the enclosed rubber bracket 4 .
Short screw (30 mm)
Long screw (55 mm)