Busch & Müller 168/35LA-01, Инструкция по эксплуатации

Страница: 24 / 100

24
5.2.2. Battery pack (for the power supply of the headlight, can also be used as a power bank)
Nominal voltage: 7.4 V – Capacity: 4,600 mAh
Load-bearing capacity
Light output and power bank, together up to 5 A:
- Light output via cable: 4,600 mAh with 5 A (without using the power bank function), when using the
power bank function, the electric current at the light output depends on the unit to be charged
- USB connection (4,200 mAh with max. 2 A usable as a power bank, in which case between 3 und 4,9 A
are available at the light output)
Charging time with original mains adapter from Busch + Müller: abt. 5 hrs.
Charging time with other USB adapters / USB port on PC: up to 12 hrs.
6. Assembly
6.1. General assembly
!
Make sure the headlight is not covered under any circumstances. Also, take care that the headlight
has been mounted and aligned as prescribed.
In Germany, the prescribed mounting height for headlights
1 ranges between about 400 and 1,200
mm. For details, consult your national Road Traffic Regulations or contact a local bicycle specialist retai-
ler. Always make sure the headlight is mounted and aligned in a way to ensure that oncoming traffic is
not blinded.
!
Not to be mounted underneath the handlebar: If the headlight is suspended, the light image is turned
upside down and oncoming traffic is blinded in violation of traffic regulations. In addition, splash water
damage can occur, the consequences of which are then excluded from our warranty.
WARNING
To avoid falls, accidents and severe injuries, always use the enclosed Busch + Müller
assembly bracket. If unsuitable or improperly positioned brackets are used, the headlight may probably
come loose, slide down and, in the worst case, get caught in the wheel spokes.
WARNING
Never mount brackets on forks or seat stays!
WARNING
Never mount brackets on conical components!
Make sure to tighten all screws in a way to ensure the headlight 1 cannot move all by itself.