Burton AIM-50, Руководство по установке, Страница: 12 / 24

10 AIM-50™ Installation Manual − Double Ceiling Version 5000147 A01
Note: Illustration is for single ceiling version, so only one transformer and a smaller terminal block is shown.
2.
Assemble the down tube by sliding it up the center hole in the ceiling casting. Position the tube
so that the lower hole (A) in the down tube is matching to the upper hole (B) in the ceiling
casting. First fasten the upper set-screw, which is a dog-point screw. (Make sure it fully engages
the matching hole in the down tube.) Then fasten the lower setscrew. Use Loctite®
Threadlocker or similar adhesive on the screws to prevent them from becoming loose.
3.
Approximately 1 inch of the down tube should be showing above the ceiling plate. A hole
through the down tube will be accessible. Put the clevis pin (B) into the hole. Secure the clevis
pin with the hairpin (A).
4.
Feed the wires coming up out of the down tube back down through the hole in the ceiling
casting (C). The wires from the wall switch should also go through this hole.