Operation
page
2
The unit will normally respond by sending an SMS message back to
the number that sent the command. The response is either the new
status of the unit or an error message if the command is not recog-
nised. If required, you can suppress the reply by placing a fullstop
after the PIN, e.g.
234
.
Fo
will set forwarding without replying.
Controlling this feature using remote text commands
• Send an SMS message to the unit, formatted as follows:
Forward landline (continued)
•
Cancel forwarding
- dial
0#4260
- Only the local phone will ring.
• Forward options (dial
0#4280
):
•
Set num extra rings delay
- dial
0#42810
- Allows you to
specify how many times the locally connected phone should
ring before the forwarding action begins - applicable to modes
0#4220
and
0#4240
only). The default setting for this feature is
0
(i.e. start forwarding immediately).
•
Missed call SMS alert
- dial
0#42820
If an incoming landline call fails to be connected with the
forwarded destination number (due to weak coverage, net-
work congestion, etc.), this feature will send a text message to
that number with a list of missed calls, the same as the ‘Who’
remote command. If the network connection is temporarily lost,
the alert message will be sent once the connection is re-estab-
lished.
Note: If the phone at the forwarding number was unavailable,
causing the network to divert the call to voicemail, then a mes-
sage would not be sent by the Burnside unit because (from its
perspective) the forwarding operation was successful.
•
Show status
(dial
0#428210
) - Indicates the current setting.
•
Alert for any call
(dial
0#428220
) - Send a text message
whenever an incoming call is not successfully forwarded.
•
Alert for call with ID
(dial
0#428230
) - Send a text message
only when an incoming call (which provides its number) is not
successfully forwarded.
•
No missed call alert
(dial
0#428240
) - Disables the feature.
•
Prompt test
- dial
0#42830
- Allows you to hear the announce-
ment that will be played to callers while forwarding takes place.
pppp
cc
ffffffff
The first 4
characters
(
pppp
)
must be
the termi-
nal PIN
(
234
as
standard,
0#51240
to
change).
After the terminal PIN (no space),
include the first two characters
(
cc
) of the appropriate command:
•
FO
RWARD Set call forwarding
to the number specified and
ring the local phone.
•
SI
LENT As per FORWARD
except local phone will not ring.
•
RI
NG As per FORWARD with
an announcement to the caller.
•
AN
NOUN As per FORWARD
with a caller announcement but
no ringing of the local phone.
•
CA
NCEL Cancels call forwarding.
Note: The two command charac-
ters are not case sensitive.
After the com-
mand, enter
number (
ffffffff
)
to forward to.
If no number
is given, unit
will use the
last number
specified. If no
last number is
stored, it will
return an error
message.
When specify-
ing international
num, use format
+nn12345678
.
Where
nn
is the
country code.
