Burn Tech GBVS 39/44/49, Инструкция по эксплуатации, Страница: 7 / 27

5
Product Overview
Introduction
Thank you for choosing Burntech® Fireplace Solutions.
Rest assured our products have been tested for safety and
durability for many years when properly installed by following
this manual completely.
Product Overview
Burntech® Fireplaces are designed as factory-built blocks to
be assembled on-site. These fireplaces may be installed on
either combustible or non-combustible floors. In order to func -
tion, the system requires a 10” B-vent chimney.
The main components of your Burntech® Fireplace are:
Burntech® Firebox and Smoke Dome
Gas burner, logs and control system (sold seperately)
B-vent Chimney Pipe(Sold Seperately)
The main categories of the installation of your Burntech®
Fireplace are:
C learance to combustibles
Familiarity with all the components for the installation
Foundation strength of your Burntech® fireplace
Chimney system measurements
Set up and use of the gas burner system.
Choice of materials and craftsmanship in fireplace and hearth
finishing.
Figure 4 - Typical Installations
Internal
Wall
Installation
Corner
Installation
Flush
Installation
Full
Projection
Installation
Note that each of these topics will be covered in detail and that
the installer is expected to understand each phase completely
before going on to subsequent instructions.
Attention : Be advised that all the illustrations in this manual
are for general reference only. Do not scale drawings. Actual
design elements will vary from case to case. Pay attention to
specified minimum clearances to combustibles.
WARNING! Under no circumstances should you allow children
to remain unattended while a fire is burning in the fireplace! Be
sure to keep all objects – furniture, drapes, rugs, etc. at least
48” (48 inches) away from the opening of the fireplace!
●
●
●
●
●
●
●
●
●
Attention : You may need a residential building permit to install
a Burntech® Fireplace. Consult local jurisdictions before you
get started !
The Burntech® gas fireplace is not designed to serve as a
primary heat source, rather, the fireplace was expressly created
as a supplemental source of heat. This unit is designed for use
with the provided gas burner and approved logs only.
Testing and listing for the Burntech® gas fireplace has been
undertaken by PFS Test Laboratories, Inc. to ANSI Z21.50.
Under no circumstances should the Burntech® gas fireplace be
considered for other than in-residence buildings of conventional
construction.
These components make up the Burntech® gas fireplace and
in the following pages, you will learn how they work together
to create an exceptional unit that will give years of service and
pleasure!
40 5/8 "
4 3/8"
7 3/8"
A/2
11"
28 "
21"
23"
C
B
4 1/4"
A
32 7/8 "
63-1/2”
D
ø
4” OUTSIDE AIR
ACCESS - CAN
BE INST ALLED
ON T HE LEFT
SIDE ALS O
Figure 5
Overall Dimensions Burntech® Fireplaces
Model A B C D
GBVS39 43” 39” 30-1/4” 27-3/4”
GBVS44 48” 44” 35-1/4” 32-3/4”
GBVS49 53” 49” 40-1/4” 37-3/4”