Burn Tech GBVS 39/44/49, Инструкция по эксплуатации, Страница: 20 / 27

18
Figure 27
Vent Plate Installation
Attention: Clearance to combustible construction can not be
reduced during course of construction. For the safe operation of
the finished fireplace, these clearances must be followed when
building the framework to house the chimney system.
Installing the valve/control box assembly
Fasten the valve/control box assembly to a stud such that
the control switch is facing in the desired direction and
flush with the future location of the finished wall or other
enclosure.
Install the two ‘D’ batteries into the battery holder within the
control box.
Run the wires for the spill switch through the small hole
in the upper wall. Important: This control box must remain
accessible and removable for service after installation.
Installing Spill Switch and Baffle assembly
Connect the blade connectors on the spill switch wires to
the matching wires from the valve/ control box assembly
coming through the upper hole in the firebox.
Center the black steel baffle with the spill switch sensor
pointed toward the room (out of the fireplace).
Use six (6) drywalls screws to fasten it in place on the front-
most part of the firebox ceiling as shown through the six (6)
pre-drilled holes.
Attach the trim plates to the left and right side of the baffle
with the sheet metal screws so that the edges are flush with
the firebrick.
Important : This baffle assembly and only this one supplied
with the kit (with spill switch) must be properly installed for the
safe operation of this gas fireplace.
1.
2.
3.
1.
2.
3.
4.
Figure 28
Figure 29
Figure 30
Trim
plate
Spillover
switch
Trim
plate
Spill sensor
wires to
valve/
control box
Owner’s Operation & Precautions
Installers of the Burntech® are urged to call the attention of
fireplace owners to the following precautions.
The installer should hand-deliver this owner’s manual to the
owner or leave behind with the unit after it the installation is
complete.
Warning : Use only the included fireplace grate or manufacturer
approved replacement.
Warning : Do not attempt to operate your fireplace without a fire
safety screen installed.
CAUTION: Use only approved gas log sets. Never use
chemical chimney cleaners. Never burn solid fuel in this
fireplace under any circumstance.