Burley G4237/8 Image, Инструкция по установке, обслуживанию и эксплуатации

Страница: 8 / 24

- 8 -
APPLIANCE DATA
Refer to the appliance data
ENSURE THAT THE LOCAL CONDITIONS OF USE CORRESPOND TO THE DATA ON THE BADGE
Natural Gas G20 Propane G31
Category I2H I3P
Supply Pressure 20mBar 37mBar
Inlet Pressure 20mBar * 37mBar *
Heat Input (net) (High)
2.5kW 2.5kW (180g/h)
(Low) 1.5kW 1.5kW (107g/h)
Inlet Connection 8mm Compression 8mm Compression
Injector Elbow 92/180 Elbow 92/90
*
The inlet pressure must be
/- 1mBar
of specification with
all
gas appliances in the house
switched on and also with just the Burley appliance operating. If outside of this tolerance the fault
is most likely to be in the installation pipe work or service governor at the meter. If the problem is
the meter governor, this is the property of the gas service provider (such as Transco / National
Grid 0800 111999 or Bord Gais) and they should be called to rectify this. The fire will not operate
correctly if the pressures are incorrect. It may be hard to light or the pilot may cut out when the
burner turns off under thermostatic control.
2.
UNPACKING THE APPLIANCE
2.1 Carefully examine the carton for damage before unpacking. If it is obviously damaged,
consult the supplier over whether to proceed.
2.2 Make sure the carton is stood upright and open the top. Remove
the cardboard top fitting; this can be used as a hearth protector
when installing the fire.
2.3 Remove the fittings boxes contained within and open them and
check the condition of the contents. Remove the fire and examine
its general condition, paying particular attention to the decorative
frame, the glass front and fire box flanges.
2.4 The fire case is attached to the chassis using clips and 2 transit
screws in the lower rear of the case. These screws can be
removed and discarded.
2.5 If satisfied by the general condition, place the decorative
components to one side and proceed with the installation. If in any doubt, seek advice
from the supplier.
Read these instructions fully before proceeding even if you have fitted
this model before.
TRANSIT SCREW