Burley G4237/8 Image, Инструкция по установке, обслуживанию и эксплуатации

Страница: 10 / 24

- 10 -
CLEARANCES TO COMBUSTIBLE MATERIALS AND SHELVES
A non combustible shelf may be fitted to within 100mm of the top edge of the fire frame. Note
that shelves will get hot and delicate ornaments, wax candles etc should be kept away from hot
surfaces.
The wood of the fire surrounds may be fitted to within 100mm of the sides of the firebox provided
it protrudes no further forward than 100mm.
Any combustible side walls must be at least 500mm from the fire bed.
Maximum depth of shelf 100mm 150mm 200mm
Minimum distance from 250mm 300mm 350mm
top of frame to underside of shelf.
As with all heaters the possibility of convection staining on surfaces in the vicinity of the heater
shall be considered and the user advised. Particular attention should be taken to ensure soft
furnishings such as scatter rugs and curtains are kept at least 1 metre from the appliance.
PREPARING THE APPLIANCE
4.1 Unpack the appliance (see 2.0). Ensure appliance is correctly marked for the gas it is to be
used with. Take the appliance components and lay them out in an ordered manner. To
prevent damage the decorative frame, fret, pebbles / coals and ceramic fire bed
components can be placed safely to one side.
Cut-outs in glass rails Internal tag X 4 (typical)
To remove the decorative trim from the glass rails it must be first raised upwards by
approximately 5cm. & then pulled forwards.
DO NOT ATTEMPT TO USE THE APPLIANCE WITH BROKEN/DAMAGED GLASS OR CERAMICS.
Contact our service department 01572 756956