Burley G4237/8 Image, Инструкция по установке, обслуживанию и эксплуатации

Страница: 14 / 24

- 14 -
Alternatively, hearth mounted appliances can use the cable fixing method by fixing eyebolts to the
wall or fireplace behind and pulling it back into place. (See diagram).
Do not fix the appliance directly to plasterboard as prolonged exposure to heat could affect it or
the vapour layer behind. A layer of heat resistant board should be screwed to the wall instead.
Fully purge pipes of air and any debris and connect the gas supply to the 8mm elbow on the fire.
Leak test the supply using an approved method. Note: An isolating valve must be situated near the
appliance for servicing.
Total Control Receiver Unit (option).
Connect the cables from the valve to the receiver as shown. Keep the cables clear of the underside
of the tray. Do not force the valve cable plug when inserting into the receiver – it only fits one
way.
HT
Lead
SW
)
(yellow
TC
(
)
red
Valve
Cable
Fit four AA (1.5V) batteries into the receiver unit and the PP3 (9V) battery into the transmitter
(hand set). Connect HT lead to receiver & terminal on the pilot assembly. Fold the heat shield as
per folding instructions supplied and position it over the receiver.
Position the thermostat where it will sense the room temperature.
The front casing can be test fitted to the chassis to ensure clearance. The gap in the casing top
between grille and spacer slides over the top flange on the appliance. The bottom of the case has
folded out brackets that slide over cut outs in the appliance chassis.
The door on the appliance is secured with a magnet and it may be necessary to adjust the strength
of the magnets grip. This can be done by bending the magnet holding bracket in or out to adjust.
6 PEBBLE / COAL LAYOUT
The base and front pebbles should be
positioned as shown overleaf. The
base locates onto the rear shelf and
sits central and pushed back. The
front pebble moulding is positioned
centrally in its channel with the cut
out on the right as shown. The coal
shapes are similar to pebbles and
fitted in a similar way.
Note the pilot position on the right
hand side of the burner.
It is important for clean burning that
the correct shape is fitted in the correct place. Do not use with incorrectly fitted pebbles.