Bürkert 2380, Руководство по эксплуатации, Страница: 15 / 23

15
Start-up
Type 2380
9. START-UP
9.1. Safety instructions
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the surrounding area.
▶
Before start-up, ensure that the operating personnel are familiar
with and have completely understood the contents of the opera-
ting instructions.
▶
Observe the safety instructions and intended use.
▶
Only adequately trained personnel may start up the device/the
system.
9.2. Start-up process
Before start-up, pneumatic, fluidic and electrical connections must
be established.
→
Switch on pilot pressure and supply voltage, keep the process
media switched off!
→
Remove the transparent cap of the controller to gain access to
the DIP switches or operating keys. Observe the special instruc-
tions for potentially explosive areas.
→
Run the function X.TUNE for an automatic adjustment of
the positioner - see respective operating instructions for the
Type 869x used.
→
For Type 8692/93: select the input signal ( INPUT) .
→
If necessary, specify additional controller settings (via DIP
switches/menu/USB adapter) - see respective operating instruc-
tions.
NOTE!
Caution with using the function SET.FACTORY
(reset to factory settings)!
This function does not only reset the settings implemented by
the user, but also all possibly preconfigured customer-specific
settings (referring to devices with additional label „Customized
Settings“)
→
Switch on process media and activate set point.
→
If necessary, adjust the controller settings.
→
Tighten transparent cap of the controller again.
The device is now ready for operation.
english