INSTALLATION INSTRUCTIONS RANGE ELECTRIC
Fitting the plinth (if applicable)
•
Ensure the appliance is raised to a
height of 915mm or above using
adjusting feet (A) before beginning.
•
Open the appliance doors andloosen
screw (C), do not remove the screw
entirely. If your appliance has a stor-
age drawer at the bottom, you access
thescrews through holes located at
the base of the drawer after lifting
the mat.
• Fit plinth (B) and secure using screw
(C).
Securing the canopy (if applicable)
• Fit screw(s) A through holes 1 and
into holes 2 at both ends of the rear
surface of the canopy.
•
Ensure that the product is level and
use the holes in the bracket as a
template and mark the fixing hole
positions.
•
Drill and plug the wall to accomodate
the product. (Note: Plugs not sup
-
plied)
•
Fixing to the wall should be car-
ried out in line with sound building
practices. (Note: Plugs and screws
not supplied)
Fitting the towel rail (if applicable)
•
On the towel rail there are two hole,
top (A) and bottom (B), these holes
have corresponding holes on the
fascia at each end.
• The screw for the top hole (A), must
be screwed into the supplied adaptor,
where as the remaining screw just
goes through the bottom hole (B).
Both screws are M6 screws. Using
the allen key provided, tighten the
screws making sure that the towel
rail is flush to the fascia, but not
over tightened.
A
1
2
A
B
DOOR
PLINTH
OVEN CAVITY
B
A
C
