Contents
Safety instructions
1
Equipment
2
Cleaning
3
Spare parts
3
Technical data
3
First test
4
Chemicals Set-Up
4
Through Hole Plating process
sequence
6
Replenishment/Bath maintenance
7
Appendices:
Electrical circuit
Chemistry Set-Up
Process Flow Table
Plating System Steps descriptions
Safety instructions
1. General
Do not use the appliance for any other
application than through hole plating
of PCB material. Read all safety in-
structions and all operating instruc-
tions thoroughly before using the unit
for the first time.
Keep these safety instructions and ope-
rating instructions somewhere safe in
case you need to refer to them again in
the future.
2. Safety warnings
In your own interest pay attention to
all safety warnings on the unit and in
the operating instructions. Follow the
instructions on operation and use of
the unit in every respect.
3. Ventilation
Wherever you put the unit, always en-
sure there is sufficient ventilation. An
exhaust system may be necessary de-
pending on your local requirements.
4. Heat and moisture
To prevent fire or the risk of electric
shock, keep this unit out of the rain and
away from moisture. Do not place the
unit close to sources of heat like radia-
tors or hot air shafts.
5. Electric power
To avoid the risk of electric shock, do
not remove the housing and do not
open the back. There are no user ser-
viceable parts inside.
Bungard Elektronik ·GmbH&Co KG· Rilke Str. 1 · D-51570 Windeck
Tel 02292 5036 · Fax 6175 · [email protected]
Compacta L30
Instructions for use
Plating line
Page 1
