Bungard ATC, Руководство оператора

Страница: 25 / 35

CCD
Operator's manual Page 25 /35
Adjusting the depth limiter – Solution 2 : Load your project and go to tab Run CNC. Mount
depth limiter as described above and roughly adjust by eyesight. Select an uncritical milling line
(e.g. a board cut line) and start routing. Press pause and check the track width. Adjust the depth
limiter and continue, till the desired track width is reached.
(ATC) Tool slots
On the right side of the machine there is a bar with 16 tool
slots. They are numbered from 0 to 15 (ATC/XL: 25 slots).
Number 0 always takes the test pin. The drill and router bits
go into the remaining 15 round aluminium slots. A tool can
move vertically in this container and a spring will shift it up un-
til the tool ring is on the same height as the tool slot.
The positions of the tool containers are known to the software
by entries to the configuration file.
Left to the tool position No. 0 there is the tool sensor. The
driver software operates the machine in a way, that after each
drill was used it is checked in this sensor. The LED on the
control unit front panel lights up when the drill is detected.
This detector also acts as a sensor for too long drills, so that
no damage to the machine bed can occur.
(MTC) Tool change
To open the spindle chuck, press down the knob on top of the
spindle and turn it left. Remove the tool and insert a new one.
Press and turn right the knob to close the chuck. To gain better access to the tool, You may lift the
spindle but it is not recommended to pull it off entirely. Tool changes during programmed drill op-
eration will lock the stepper motor axes, so that no unwanted malpositioning can occur.
Maintenance
It is important that you regularly remove
all dust and shavings from the machine.
To clean and lubricate the steel shafts,
especially those below the aluminium ex-
trusions on the X-axis, use a cloth and
some acid-free machine oil. On each end
of the linear bearing housings, there are
lubricating felt stripes. Regularly apply
some oil to them.
The shafts on the Z-axis do not need
special lubrication but must also be kept
clean.
Note : The machine must not be used in
corrosive or inflammable atmospheres. If
it will not be used for a longer period or
prior to transporting it, all steel shafts
should be well lubricated.
The drive belts must also be kept clean from dust and shavings but must not not be lubricated.
The belts are subject to wear. If they show damages like lateral fray-out or deformed teeth they
should be replaced.
13: tool containers