Bungard ATC, Руководство оператора

Страница: 12 / 35

CCD
Operator's manual Page 12 /35
In the picture on the right you can see an axis and
zero-point overview. All CCD machines are set up,
so that the motor connection box with the cables is
located on the left and the stepper motor of the Y-
axis facing the front. On the right there are the tool
slots (ATC-machines). If you stand in front of the
machine that way, then the
machine zero is on the
front left , the X-axis is on the table level between
motor connection box and tool slots, the Y-axis is
the upper cross traverses and the Z-axis with the
spindle sits on the traverse and moves vertically .
The only exception is the CCD/2: this machine is set
up in a way that the RS232 port and control diodes
are pointing forward. Again, the
zero point is at the
front left , but the Y-axis is in the table level of the
table and the X axis is the cross-traverses over the
table and on this X-axis hangs the Z-axis with the
spindle.
USB/Serial adapter: If you want to operate the CCD via a free USB
port on your computer, then you first put the USB / serial adapter into
the free USB-socket. Normally a routine for detecting new hardware in-
cluding driver installation will start.
Insert at this point the small CD that came with the adapter and follow
the instructions on the screen. This installation is in two stages, which
look very similar. First a USB device is installed, secondly a virtual
COM port. So you will be prompted twice to install a driver. Do not stop
the process after the first time. Even if you later plug in the same adapter into a different USB
port, you possibly are again prompted to install the driver.
With Windows 7, it may be necessary to install the driver via the device manager.
RoutePro3000: Now insert the enclosed CD into your
computer drive and start SetupRoutePro3000.exe.
Depending on the system the modules
Windows
Framework 4 and Visual C++ must be installed on
your system. In general this happens automatically.
For this and for the registration of the software an in-
ternet connection is required. For the start we can
skip the registration procedure by clicking
continue
without registration . Please refer to the installation
guide and the RoutePro3000 online help for details.