PANEL PRO
5
1. After removing the crate top, remove the 2x2s in the top ends of the crate.
2. Remove the screws in the shipping tabs at the ends of the Panel Pro. A long
extension is helpful here.
3. When unpacking or lifting the Panel Pro, take care to lift only on the square structure
on the ends, or the ½” mount rails mounted near the ends, or the Y axis plate near
the ends. Do not lift on the Y axis base plate (3/8 x 8 x 38 plate) near its center,
only at its ends. Never lift or put pressure on the lead screws.
4. Attach leg glides (inside tool box) to legs. Set near maximum extension.
5. Remove the shipping tabs, discard the washers.
6. Have all of the 6mm leg mounting screws barely started.
7. Attach the legs with 4 6mm socket screws each, using a
5mm Allen wrench with extension.
A 5mm Allen bit is
included in the tool box.
Two people are required.
Stand the base unit on the end of the drain pan and
have one person support it in that position while the
other attaches the legs.
DO NOT APPLY PRESSURE
TO THE LEAD SCREW, or LEAD SCREW
SUPPORTS!
