Manual Builder extreme 1000/1500/2000 pro
Extreme Builder Pro Manual Eng V2
22
Start Printing
Auto home
When you power up your extreme the machine has to be auto-homed. You can only move the machine
when this action is done.
Adhesive layer
For perfect adhesion between your print and the glass build surface be sure that the layer of glue is in
perfect state. Check this before the start of every print. The layer of glue has to cover the complete glass
build surface. If the layer is not covering the complete build surface, apply a new layer using the supplied
paint roller set and the wood glue. Put 1/3 glue and 2/3 water into the paint roller set and give it a good
mix. Before applying the glue to the glass surface pre heat the build plate to 50°C, then apply the glue to
the glass surface using the paint roller.
Apply an even coat and be sure that no glue is coming under the
glass build plate!!
Preheat
It can be convenient to pre heat the Extreme Builder when in the mean time doing some
preparations before starting the actual printing process. Pre-heating can be done using the user
interface.
Timeout Heater
When the machine is not used for 30 minutes, the machine stops heating. The print head stops
heating after 30 minutes, the heated bed after 3 hours. After your print is finished, al heaters will
stop heating automatically.