Https://www.bueno-electric.com
BUENO ELECTRIC
BUENO ELECTRIC
BUENO ELECTRIC
BUENO ELECTRIC
Contact: [email protected] Fax: +86-25-51816989
2.3 Install Methods
1. Switch off all power supply before installation.
2. Connect the local “TX” Fiber Optic to the remote “RX” Fiber Optic, the local “RX” to the
remote “TX”. And ensure that fiber is properly aligned to the receiving connector.
3. Connect the “
D
0
+”
Data of the CANH and the “
D
0
-
” Data to the CANL. Then screw down
the bolt.
4. On the bottom of the Converter, there is a DIP Switch.,
When the SW0 is “ON”,it's
connected to 120 Ohm terminal resistance .
DIP Switch setup table: 120 ohm Terminal Resistance
DIP Switch pin name SW0 Others
Setup State
OFF
OFF
Baud rate rotary switch button setup table:
“B0 Button Position
9
8
7
6
5
4
3
2
1
0
CAN Baud Rate
80Kbps
100Kbps
125Kbps
200Kbps
250Kbps
400Kbps
500Kbps
666Kbps
800Kbps
1000Kbps
Note:
When the B0 is switched to F position, you can configure the baud rate through the serial DB9 port.
DIP Switch pin name
SW0
Others
Setup State
ON
OFF
A
B
C
D
E
F
50Kbps
40Kbps
20Kbps
10Kbps
5Kbps
configuration
