Https://www.bueno-electric.com
BUENO ELECTRIC
BUENO ELECTRIC
BUENO ELECTRIC
BUENO ELECTRIC
Contact: [email protected] Fax: +86-25-51816989
2.4 Configure the baud rate by software
Switch the “B0” button to F position and connect the straight line(NOT cross line) to the
console port(DB9) and the other end of the line to the computer.
1.Open CANConfig and click“CAN FIB-100BT”,you will see 3 options: Basic Info,Baud rate and Filter.
2.Software Configuration
(1) Open RS232
：
Communicate with the serial RS232.
(2) Read Parameter
：
Read all parameters of the device and display them.
(3) Write Parameter
：
Write all parameters into the device.These parameters will be stored to the
flash and read them automatically when powers on.
3.Device Parameters
3.1 Basic Info
Click the “Open RS232” and read out all information by clicking “Read Parameter” button.The “Basic
info” option contains the vendor ID,device type,device code,hardware version,software version and
serial numbers.
3.2 Baudrate
“
Baudrate” is for setting up the baud rate of all channels of the device.When the rotary button is
switched to”F” position,you can configure the baud rate on it.See the below figure and baud rate
table:
